by KenK | Jan 19, 2014 | Banjo
I ordered some of the parts I need from Stewart-MacDonald and they arrived yesterday. The first photo is of the tone ring I chose. The tone ring lies on the front edge of the rim under the head. It is used to improve the sound over using the wooden rim alone....
by KenK | Jan 13, 2014 | Banjo
Here are some videos highlighting clawhammer style banjo playing. Steve Martin plays in two of these. I guess it helps to have a sense of humor if you are going to play the banjo. Mark Johnson in the second one is awesome. Michael Neverisky in the third has a few...
by KenK | Jan 13, 2014 | Banjo
Using some maple trimmed off the original lumber when squaring it up, I cut two pieces for ears. These will widen the peghead enough for the pattern I chose. The ears are approximately the same thickness as the peghead. The front surface of the peghead has...
by KenK | Jan 12, 2014 | Banjo
Here I have laid out the maple filler pieces and the truss rod beside the neck to illustrate how they are installed inside the neck. The shaped pieces will keep the rod in a curved shape relative to the neck. I took this picture before I made one more filler piece...
by KenK | Jan 11, 2014 | Banjo
A 3/16in steel rod will be installed in the neck to provide for some ability to counteract the tension from the strings. Below I am cutting a 1/4in wide slot on the table saw. Below is the finished slot for the truss rod seen from the peghead end of the neck. ...
by KenK | Jan 5, 2014 | Banjo
After copying the pattern onto the wood, I started to cut the side profile out using the bandsaw. Here I have the back of the peghead cut and the bottom of the heel The glue joint looks good! Here is the neck with the side profile all cut out. You can see that...
Recent Comments